Advanced setup —continued, Audio adjust functions – Onkyo TX-SA705 User Manual

Page 85

Advertising
background image

85

Advanced Setup—Continued

Here you can set listening mode-related settings and
functions.

Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
The Audio Adjust functions are explained below.

Tone Control Settings

You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio or THX listening
mode is selected.

Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.

Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.

Multiplex/Mono Settings

Multiplex Input Ch
This setting determines which channel is output from a
stereo multiplex source. Use it to select audio channels
or languages with multiplex sources, multilingual TV
broadcasts, and so on.

Main: The main channel is output (default).

Sub: The sub channel is output.

Main/Sub: Both the main and sub channels are output.

Mono Input Ch
This setting specifies the channel to be used for playing
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening
mode.

L+R: Both the left and right channels are output

(default).

L: Only the left channel is output.

R: Only the right channel is output.

Output Speaker
This setting determines which speakers output mono
audio when the Mono listening mode is selected.

L/R: Mono audio is output by the front left and right

speakers.

C: Mono audio is output by the center speaker

(default).

Audio Adjust Functions

1

Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.

2

Use the Up and Down [

]/[

]

buttons to select “3. Audio
Adjust,” and then press [ENTER].
The Audio Adjust menu appears.

3

Use the Up and Down [

]/[

]

buttons to select the functions,
and then press [ENTER].
The function menu you selected
appears.

4

Use the Up and Down [

]/[

]

buttons to select the settings,
and use the Left and Right [

]/

[

] buttons to set them.

The settings are explained below.

ENTER

ENTER

3. Audio Adjust

1. Tone Control
2. Multiplex/Mono
3. PL II x/Neo:6
4. Dolby EX
5. Theater-Dimensional
6. LFE Level

ENTER

ENTER

ENTER

ENTER

5

When you’ve finished, press the
[SETUP] button.
The setup menu closes.

Advertising
This manual is related to the following products: