Onkyo TX-SA705 - Manual (Page 84)

84
Advanced Setup—Continued
Note:
• This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP],
[ENTER], and arrow buttons.
Subwoofer Input Sensitivity
Some DVD players output the LFE channel from their
subwoofer output at 15 dB higher than normal. You can
change the subwoofer sensitivity to match your DVD
player. Note that this setting only affects signals con-
nected to the SUBWOOFER input jack of the multichan-
nel DVD input.
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
4 Use the Left and Right [ ]/[ ]
buttons to specify the distance
between your surround back
speakers:
< 1 ft (< 0.3 m) (Default): Select this if
your surround back speakers are
between 0 and 1 foot (0–30 cm) apart.
1–4 ft (0.3–1.2 m): Select this if your
surround back speakers are between 1
and 4 feet (0.3–1.2 m) apart.
>4 ft (>1.2 m): Select this if your sur-
round back speakers are more than 4
feet (1.2 m) apart.
Note:
This setting is only available if the Surr
Back Ch setting in the Speaker Config-
uration is set to 2ch (page 78).
5 Press the [SETUP] button.
The setup menu closes.
Multichannel DVD Input Settings
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [ENTER].
The Hardware Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “4. Analog Mul-
tich,” and then press [ENTER].
The Analog Multich menu appears.
4 Use the Left and Right [ ]/[ ]
buttons to select a value.
You can select 0 dB, 5 dB, 10 dB, or
15 dB.
If you find that your subwoofer is too
loud, try the 10 dB or 15 dB setting.
5 Press the [SETUP] button.
The setup menu closes.
ENTER
ENTER
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
ENTER
ENTER
7–4. Analog Multich
Subwoofer Input Sensitivity 0dB