Onkyo TX-SA705 - Manual (Page 94)

94
Advanced Setup—Continued
. Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
Changing the AV Receiver/AV
Amplifier’s ID
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [ENTER].
The Hardware Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “1. Remote
Control,” and then press
[ENTER].
The Remote Control menu appears.
4 Use the Left and Right [ ]/[ ]
buttons to select a value.
Remote ID
With this setting, you can change the
AV receiver/AV amplifier’s remote con-
trol ID. You may need to change this if
the remote controller’s control codes
overlap with those of another Onkyo
component located in the same room.
If you change the AV receiver/AV
amplifier’s remote control ID, be sure
to set the same ID on both the AV
receiver/AV amplifier and remote con-
troller (see page 98). The default ID for
both is 1.
ENTER
ENTER
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
ENTER
ENTER
7–1. Remote Control
Remote ID 1