Oneida Air Systems Super Dust Gorilla - Manual (Page 8)

7
2HP Super Dust Gorilla Owner’s Manual O.A.S. 2007 c
VI. General Assembly Instructions
Cyclone
Barrel
Cyclone
Cone
2.
Cyclone
Barrel
Air Inlet
Fan /
Blower
Housing
Before you start, make sure you have cut and placed
the provided gasket material on top and bottom of the
Fan/Blower housing and the Cone as shown in the
diagrams. Then determine which direction you want
your filter to hang and which direction your ductwork
will enter the collector.
Air
Outlet
Gasket
Material -
Outside of
Bolt Circle
on underside
of Housing.
Silicone nuts.
There are essentially three ways to assemble your collector
and to attach it to the bracket. The way that is right for you
should be determined by expertise and manpower available.
When the units are all assembled they are very heavy and top
weighted. All of this should be taken into account before
deciding on the method best suited for you.
Do NOT use hook on motor to lift unit.
3.
3/8” Bolt / (2) Washers /
Serrated Nut per bolt hole
on each side and back.
4.
Collector
Hose Clamp
Hose Clamp
Flex Hose
Dust Bin
Gasket
Material
(12) 3/8” Bolts
(24) Flat Washers
(12) Serrated Nuts
Bolt
Washer
Flange
Washer
Nut
Gasket Material -
Outside of
Bolt Circle on top
of Housing.
To further eliminate
air leaks, a small
amount of silicone
should be used on
nuts used to
secure motor plate.
Motor
& Plate
Method #1 -
Bolt Fan/Blower housing to Cyclone barrel. Then bolt
Motor and Plate to Fan/Blower housing. Carefully lay
unit on its side and then bolt cone to barrel. Lift entire
unit up onto wall braket. Unit is extremely heavy and
top weighted, be advised!
Method #2 -
Bolt Fan/Blower housing to Cyclone barrel. Then bolt
Motor and Plate to Fan/Blower housing. Put Cone up
on Wall Bracket and orient holes. Lift assembled unit
onto cone making sure proper holes are lined up. Bolt
unit to bracket, then finish bolting barrel to cone.
Method #3 -
Bolt Fan/Blower housing to Cyclone barrel. Put Cone
up on Wall Bracket and orient holes. Lift assembled unit
onto cone making sure proper holes are lined up. Bolt
unit to bracket, then finish bolting barrel to cone. Lift
Motor & Plate onto Fan/Blower housing and bolt together
in proper direction.
GORILLA
The TM
GORILLA
The TM
GORILLA
The TM
With all assemblies, make sure
rectangular air outlet is oriented on
Fan/Blower housing as you are
looking down as in Fig. 1A or facing
it as shown in diagrams. This is very
important. Then you can rotate
housing to whatever bolt position is
best for your shop.
1.
Gasket
Material -
Inside of
Bolt Circle
TOP
TOP
VIEW
TOP
Fig. 1A
Note: For cyclonic preseparation there must be an air tight seal between cyclone and dust
container. Dust bin must be located vertically under cyclone, material drops down by gravity.