Onkyo DV-SP800 - Manual (Page 68)

68
Register the Codes of Other Unit's Remote
Controllers
Register the codes of other unit's (TV
or VCR) remote controllers
Use this feature to register the remote codes of other
remote control units. Please look up your TV/VCR from
list of remote control codes starting on page 69.
While pressing and holding down
the desired MODE button (VCR or
TV) on the remote controller press
+10 and then release both buttons.
When you press and hold down the
desired MODE button, the SEND/LEARN
indicator lights up. When you press the
DISPLAY button, the indicator turns off.
When the SEND/LEARN indicator turns
off, release the buttons and the indicator
lights up again.
Use the number buttons on the
remote controller to input the
TV/VCR three digit remote control
code.
The SEND/LEARN indicator flashes twice
slowly to indicate that the command has
been successfully programmed.
If you perform an invalid operation, the
SEND/LEARN indicator flashes three
times quickly. Follow the same procedure
again.
1
2
POWER
POWER
Program Channel +
Program Channel –
Volume +
Volume –
TV/VCR
Mute
1
2
3
4
5
6
7
8
9
+10, --/---
0
ENT, OK
RC-498DV button names TV
POWER
POWER
Program Channel +
Program Channel –
TV/VCR
Play
Stop
FF
FR
1
2
3
4
5
6
7
8
9
+10
0
ENT, OK
PAUSE
VCR
(ON)
(STANDBY)
CH +
CH –
VOL %
VOL fi
A/AUDIO SEL/TV/VCR
VIDEO OFF/M/MUTING
£
7
¡
1
1
2
3
4
5
6
7
8
9
+10
0
ENTER/SEARCH
(PAUSE)
Operate other units with the registered
codes
If you are unable to operate other units with the
RC-498DV remote, perform the registration procedures
again.
ENTER
AUDIO SEL
VIDEO OFF
DISPLAY DIMMER
MODE
TV / VCR
REMOTE CONTROLLER RC-498DV
SEND / LEARN
STEP/ SLOW PAUSE STEP/ SLOW
MUTING
PRE PROG RAMMED & LEARNING CAPABILIT Y
INPUT SELECTOR
AU DI O
TV
SUBTTL
LAS T M
ANG LE
VOL C H
DV D
RCVR VCR
ON STANDBY
TV.VC R
ENTER
A-B PICTURE COND M FUNCTION M
SPEED SURROUND
RANDOM PROGRAM CLEAR REPEAT
-- / ---
SEARCH
1 2 3
4 5 6
7 8 9
+10 0
INPUT SELECTOR
SEARCH
SEND/LEARN
TO P M ENU MEN U
RE TUR N SET UP
VCR
TV
Erasing Registered codes
1
2
Remove the batteries from the
remote controller.
While pressing and holding down
the ON and STANDBY buttons,
reinsert the batteries.
Press the SEARCH button.
3
Note
The above procedure will completely remove all registered codes
from the remote controller.