Onkyo DV-SP800 - Manual (Page 9)

9
Before You Start
Notes
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if the remote controller is
not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
replace both batteries at the same time.
• The life of the batteries supplied is about six months but this will
vary depending on usage.
30˚
30˚
About 5 m
Remote control sensor
1 Open the battery compartment cover.
2 Insert the two R6 (size AA) batteries.
Be sure to match the + and – ends of the batteries
with the diagram inside the battery compartment.
3 Close the battery compartment cover.
Inserting the Batteries
Using the Remote Controller
Point the remote controller toward the remote control
sensor.
Notes
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of the
remote controller.
• Using another remote controller of the same type in the same room
or using the unit near equipment which uses infrared rays may
cause operational interference.
• Do not put any object such as a book on the remote controller. The
buttons of the remote controller may be pressed by mistake and
drain the batteries.
• Make sure the audio rack doors do not have colored glass. Placing
the unit behind such doors may prevent proper remote controller
operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
Setting the Voltage Selector
(Worldwide models only)
Worldwide models are equipped with a voltage selector to
conform with local power supplies. Be sure to set this switch
to match the voltage of the power supply in your area before
plugging in the unit.
Determine the proper voltage for your area: 220-230 V or 120
V. If the preset voltage is not correct for your area, insert a
screwdriver into the groove in the switch. Slide the switch all
the way to the upper (120 V) or to the lower (220-230 V),
whichever is appropriate.
DIGITAL
OUTPUT
OPTICAL COAXIAL
S VIDEO VIDEO Y CB/PB CR/PR COMPONENT 1
VIDEO
OUTPUT
ANALOG
OUTPUT L
R
L
R
SURR
1 1+2
CH 1 CH 2 FRONT SURR 1 CENTER SURR 2
SUB WOOFER
AC INLET
REMOTE CONTROL
MODEL NO. DV-SP 800 SACD & DVD AUDIO/VIDEO PLAYER
120 V
VOLTAGE
SELECTOR
220-230 V
120 V
VOLTAGE
SELECTOR
220-230 V