Oki 6120i - Manual (Page 179)

V - 5
Section 5 - Chapter 2 - Installation
OKI OkiLAN 6120i User’s Guide
LAN Manager/ Server
Chapter 2
Installation
Overview
To install the OkiLAN 6120i:
1. Install the OkiNet for OS/2 utilities software.
2. Run the OkiNet for OS/2 utility to add a local printer
port.
3. Associate a print queue with the new local printer
port.
Once the installation is complete, you can verify
communication by printing a configuration sheet.
Network Preparation
• You must have network administrator privileges to
install the OkiLAN 6120i.
• You must have physical access to an OS/2 file server
to host the OKI software utilities.
• Write down the serial number and the Ethernet
address of your OkiLAN 6120i.
• OS/2 and LAN Manager/LAN Server must be
configured with the following protocol:
DLC/802.2 protocol stack
• LAN Manager users must enable the remote boot
facility.
• LAN Server 2.X users must run the LAN Server
installation utility and select the 802.2 protocol.
• LAN Server 3.0 users must run the LAPS utility and
select the 802.2 protocol.
• OS/2 Warp Users must run the MPTS utility and
select the 80w.w protocol. See your network
administrator or the LAN Manager/LAN Server
manuals for instructions.