Oki 6120i - Manual (Page 98)

IV - 5
Section 4 - Chapter 1 - Introduction
OKI OkiLAN 6120i User’s Guide
TCP/IP
Chapter 1
Introduction
Overview
This section contains instructions and information on
how to configure your OkiLAN 6120i. You will also be
instructed on how to set up your host computers to print
to the OkiLAN 6120i using the TCP/IP protocol.
OkiLAN 6120i supports TCP/IP methods for printing:
• Remote Line Printer Daemon (LPD)
• File Transfer Protocol (FTP)
• Printing directly through a TCP port (Raw Port
Printing)
Additionally, if the DHCP protocol is enabled as a
default, the print server may be accessed through an
ordinary Internet Web browser, such as Netscape
Navigator, or by using TELNET. See Chapters 5 and 6
in this section.
Software Requirements
The OkiLAN 6120i may be configured for TCP/IP
using the OkiNet for TCP/IP utility, or from a computer
supporting the OkiNet for NetWare utility, Banyan
VINES OkiNet for VINES utility (may apply to other
OkiLAN print server models), OR telnet and one of the
following:
• Manual arp table entry and ping
• Static route entry using route add command
• DHCP
• RARP
• BOOTP