Olicom 9600 - Manual (Page 22)

9600 Compressor Installation, Operation, and Maintenance
P/N 8040540 2-1
C
HELIX TECHNOLOGY CORPORATION
- TI CRYOGENICS
Section 2 - Unpacking and Inspection
Introduction
The 9600 Compressor is shipped in a shipping carton incorporating a ramp
system which makes removing the Compressor from the carton safe and
easy.
Shipping Carton Inspection
Inspect the exterior of the shipping carton for visible signs of damage
before opening the shipping carton. Report any damage to the shipping
company at once.
Removal from Shipping Carton
1. Cut the two straps on the exterior of the shipping pallet.
2. Lift the cardboard carton straight up and remove it from the
pallet.
3. Cut the tape which holds the ramp in the vertical position.
4. Swing the ramp down until the end touches the floor as shown in
Figure 2-1.
5. Remove any excess shipping material from around the Compressor.
WARNING
Be certain to maintain control over the movement of the Compressor
as it rolls down the ramp. Injury to personnel may result if the
Compressor is allowed to roll freely down the ramp.
CAUTION
Be certain to maintain control over the movement of the Compressor
as it rolls down the ramp. Damage to the Compressor may
result if the Compressor is allowed to roll freely down the ramp.
6. Unlock the swivel casters as shown in Figure 2-1.
7. Carefully roll the Compressor down the ramp and onto the floor as
shown in Figure 2-1.