Orbit Manufacturing Rokonet ORBIT-6 RP-206 - Manual (Page 13)

Installer Manual
13
Operation Action Comments
1 Enter the
Installer
Programming
mode
enter the factory default
Installer Code (
0-2-0-6);
followed by
#
a long beep will sound, confirming
successful entry into Installer
Programming
2 Access the
current Installer
Code
(stored in location
“08”)
press
[0], [8], [ARM]
no confirming beep will sound
3 Enter a unique
Installer Code
(for this tutorial,
we’ll use 3-0-5-7)
enter
[3], [0], [5], [7]
no confirming beep will sound
4 Store the data
you have entered
press
[#]
a long beep will sound confirming that
data has been properly stored
if a wrong number of digits entered
three (error) beeps will sound after
pressing #
press
keys
displayed zone
LEDs
lit
value
none 1
st
digit 2, 1 3
STAY
STAY
2
nd
digit none 0
STAY
STAY
3
rd
digit 3,1 5
STAY
STAY
4
th
digit 3,2,1 7
5 Check the data
stored in Location
“08” •
the first digit of the stored
data will appear
•
observe the Zone LEDs
•
press
[STAY] [STAY] to
advance to the next digit
•
once all four digits have
been displayed, attempts to
view an additional digit will
result in three (error) beeps
•
if desired, press
[STAY]
and
[ARM] to move
backwards
6 Go to another
location of your
choice
press the desired two-digit
location and
[ARM]
press
[ARM] alone to go to the next
sequential location
7 Exit
programming
enter your Installer Code
and press
[ARM]
a long beep will confirm your actions