Omnitron Systems Technology RS-232 - Manual (Page 67)

11. The wizard will install the FTDIBUS.INF driver. When finished, the
following message will appear: “The wizard has finished installing the
software for ID TECH - USB High Speed Serial Converter.
12. Click FINISH.
13. A “Found new hardware wizard” window should again appear on the
screen.
14. As before, select “Install from a list or specific location” and click
NEXT. The host should display another window: “Please choose your
search and installation options”
15. Select “Don’t search, I will choose the driver to install” and click
NEXT. You will be asked to select the hardware type. Select “Show all
devices” and click NEXT.
16. You will be asked to “select the device driver you want to install for
this hardware.” Select SHOW ALL DEVICES and HAVE DISK and then
click NEXT.
17. The INSTALL FROM DISK window will appear. Click BROWSE.
18. The LOCATE FILE window will appear. Find C:\ID TECH USB Serial
Driver V3.0. Select FTDIPORT.INF and click OPEN.
19. Click OK on the next window. The following will appear: “Select the
device driver you want to install for this hardware.” You will also notice a
warning that the driver is not digitally signed. Click NEXT. A Windows XP
warning will appear: “This driver is not digitally signed.” Click CONTIN-
UE ANYWAY.
20. The wizard will install the FTDIPORT.INF driver. When finished, the
following message will appear: “The wizard has finished installing the
software for ID TECH - USB High Speed Serial Port.
21. Click FINISH. Both drivers are now installed, and the USB/RS-232
device should be fully functional.
For Type A ID TECH USB/RS-232 devices, it will be necessary to reinstall
the driver for each unit connected to the host. For Type B ID TECH USB/
RS-232 devices, it will only be necessary to install the driver once for each
PC and USB port.
61