Qwest SCP-3200 - Manual (Page 148)

132 Section 2I: Using Ready Link
Making a Ready Link Call by Entering a Number
To place a Ready Link call by entering a number:
1. From standby mode, enter the Ready Link number you want to dial.
2. Press to place the Ready Link call. Continue holding to
take the floor and speak.
Ⅲ The contact’s name is displayed if there is a matched number in
your Ready Link List.
3. Continue with the Ready Link call, pressing and holding to
speak and releasing it to allow others to reply.
4. When the call is finished, press .
– or –
1. Press .
2. Select Go to (left softkey), highlight Enter R-Link# and press .
3. Enter the Ready Link number you want to dial.
4. Follow steps 2–4 above.
Note: Ready Link numbers must contain 10 digits (area code + phone number)
or 11 digits (1 + area code + phone number). Your Ready Link number is
the same as your wireless phone number.