Qwest SCP-3200 - Manual (Page 49)

Section 2A: Phone Basics 33
End-of-Call Options
To display the following options, press Options (right softkey) within
10 seconds after disconnecting a call. To select an option, highlight it
and press
.
ⅷ Call Again to dial the phone number.
ⅷ Call:Speaker On to dial the phone number in speakerphone mode.
ⅷ Send Message to send a Text or Picture Mail message.
ⅷ Save Phone# to save the phone number in your Contacts list.
Ⅲ Go to Ph. Book is displayed when the number is already in your
Contacts list. (See “Saving a Phone Number” below.)
ⅷ Rename to change the current entry’s name to Caller ID name
(if applicable).
Saving a Phone Number
Your phone can store up to 500 phone numbers in up to 300 Contacts
entries. (An entry may contain up to seven numbers.) Each entry’s name can
contain 32 characters. Your phone automatically sorts the Contacts entries
alphabetically. (For more information, see Section 2F: Using Contacts on
page 95.)
To save a number from standby mode:
1. Enter a phone number.
2. Press Options (right softkey) > Save Phone#.
3. Select from the following entry modes:
Ⅲ New Name to enter a new name.
Ⅲ From Ph. Book to select a name from the Contacts entry list.
4. Select a label and press .
5. Press Save (left softkey).
6. Press Done (left softkey) to return to standby mode.
Note: The End-of-Call options are not displayed for calls identified as No ID or
Private.
Phone Basics