Qwest SCP-3200 - Manual (Page 150)

134 Section 2I: Using Ready Link
Receiving a Ready Link Call
To receive a Ready Link call:
1. Make sure your phone’s Ready Link mode is enabled. (See “Setting
Ready Link Mode” on page 127.)
2. When you receive a Ready Link call from a contact, “R-Link Call,” the
contact’s name and the Ready Link number are displayed. (You do not
need to take any action to answer the call.)
Ⅲ When you receive a group call, “Group Call,” the group member’s
name, and the Ready Link number are displayed.
3. If the person placing the call has kept the floor (held the Ready
Link/Voice Memo key), you will see the contact’s name and Ready
Link number along with “has floor,” and you will hear the caller
speaking.
4. When the caller finishes speaking and releases , you will see
“Floor is open” on the display screen. Press and hold to take
the floor and reply to the caller. (You will see “You have floor” and hear
a tone confirming that you may speak.)
5. When the conversation is finished, press .
Note: You can change the volume and the speaker setting while a Ready Link
call is activated.
Volume: Adjust the voice volume by using the side
volume key or by pressing the navigation key up or down (except when
you are pressing and holding the Ready Link/Voice Memo key).
Speaker: Switch the speaker on or off by pressing SPEAKER .
Tip: You can also receive a Ready Link call with the phone closed. Press and
hold the Ready Link/Voice Memo key to take the floor when the floor is
open.