Quantum Tape Drive LTO-3 - Manual (Page 79)

Chapter 6 UNIX Settings
Configuring for HP-UX 11.0
LTO-3 Tape Drive User’s Guide 65
•
x
is the data under
H/WPath
from the
ioscan
.
•
y
is the data under I from the
ioscan .
•
z
is the tape device identifier number.
You can execute an
ls
command for the
/dev/rmt
directory to choose an
identifier number that has not already been used. You can also choose a
unique device name such as cnb to more easily remember which device
name will enable data compression during write. Refer to the man pages
for mksf to review settings for r
ewind/no rewind
,
Berkeley mode
, and
AT&T mode
.
After performing the
insf
and
mksf
commands, use the command
ioscan –fn | grep –C tape
to check the installation. You should see
output showing the hardware and device addressing and also the device
name attached to the LTO-3 Tape Drive.