Quantum Tape Drive DLT VS80 - Manual (Page 18)

Chapter 3: DLT VS80 Installation
3-4 May 2004 001596-01 Rev A07
3.2.2 Setting the SCSI ID
All SCSI devices attached to the server or workstation must have a unique SCSI ID. Check the SCSI
IDs on all other devices on the selected server or workstation, including the SCSI host bus adapter, and
select an unused SCSI ID for your tape drive. The factory default SCSI ID for this tape drive is 5, as
shown in
Figure 3-1 . If the tape drive’s factory default SCSI ID is not already in use by another device
on the same SCSI bus, you do not need to change the SCSI ID.
N OTE : If the tabletop tape drive is attached to a narrow SCSI bus, only IDs 0
through 7 are valid. If it is a wide SCSI bus, then you can use IDs 0
through 15.
Figure 3-1. Tabletop Tape Drive Rear Panel Layout
68-pin high-density SCSI connectors
On
Off
SCSI ID switch
Power
switch
Power
cable connector
5