Terminating your internal tape drive, Terminating your internal tape drive -12, Figure 3-7. terminator installation -12 – Quantum Tape Drive DLT VS80 User Manual

Page 26

Advertising
background image

Chapter 3: DLT VS80 Installation

3-12

May 2004

001596-01 Rev A07

Terminating Your Internal Tape Drive

You must terminate the tape drive if:

•

It is the only SCSI device—other than the SCSI host bus adapter—on the selected server or
workstation’s SCSI bus.

•

It is the last SCSI device on the selected server or workstation’s SCSI bus.

To terminate the tape drive, insert an active low-voltage differential (LVD) or multimode LVD/SE
terminator into the connector on one end of the SCSI ribbon cable as shown in

Figure 3-7

. You can use

a cable-end terminator as shown in

Figure 3-7

or an inline terminator, whichever is most convenient.

Continue with the rest of the installation as usual.

Figure 3-7.

Terminator Installation

Terminator

SCSI cable

Advertising