Quantum Tape Drive DLT VS80 - Manual (Page 27)

DLT VS80 Tape Drive Installation and Operations Guide
001596-01 Rev A07 May 2004 3-13
N OTE : If the SCSI cable that came with the SCSI host bus adapter already has a
terminator built into it, do not use another terminator. An example of such
a cable is shown in
Figure 3-8 .
3.3.3 Installing Your Internal Tape Drive
In the final installation stages, you install your tape drive in the server or workstation and connect the
SCSI and power cables.
To install your internal tape drive, follow these steps:
1. Shut down the operating system and power off the selected server or workstation.
2. Power off all peripheral devices such as printers and other SCSI devices.
Figure 3-8. SCSI Cable with Built-in Terminator
C AUTION Do not go to step 3 until you have completed steps 1 and 2.
Failure to follow these instructions may result in damage to
the tape drive or other devices.
Terminator
SCSI cable
(supplied with
host bus adapter)