Quantum Tape Drive DLT VS80 - Manual (Page 20)

Chapter 3: DLT VS80 Installation
3-6 May 2004 001596-01 Rev A07
4. Connect one end of the SCSI cable to one of the connectors on the rear panel of your tape drive, as
shown in
Figure 3-3 . Either SCSI connector works equally well.
N OTE : Figure 3-3 does not show a terminator because none of the three tape
drives in the illustration are at the end of the SCSI bus.
Figure 3-3. Tape Drive SCSI and Power Cable Connections
To next
device
To SCSI
host bus adapter