Quadra-Fire QVI-30FB User Manual

Page 22

Advertising
background image

Quadra-Fire • QVI-30FB • 2020-900 Rev. H • 9/07

22

4

Maintaining and Servicing Your Appliance

Appliance Maintenance

Although the frequency of servicing and maintenance will
depend on use and the type of installation, you should have
a qualified service technician perform an appliance check-
up at the beginning of each heating season. See the table
below for specific guidelines regarding each fireplace main-
tenance task.

IMPORTANT: TURN OFF THE GAS BEFORE SERVICING
YOUR FIREPLACE.

Replacing old ember material
Frequency:
Once annually, during the checkup.
By: Qualified service technician.
Task: Brush away loose ember material near the burner.
Replace old ember material with new dime-size and shape
pieces of Golden Ember (DE-93) and Glowing Ember (050-
721). New ember material should be placed alternately on
top of the burner - a layer of Golden Ember, a layer of
Glowing Ember, and so on. Save the remaining ember
material and repeat this procedure at your next servicing.
For more information, see Placing Ember Material.

Cleaning Burner and Controls
Frequency:
Once annually.
By: Qualified service technician.
Task: Brush or vacuum the control compartment, fireplace
logs and burner areas surrounding the logs.

Checking Flame Patterns, Flame Height
Frequency:
Periodically.
By: Qualified service technician/Home owner.
Task: Make a visual check of your fireplace’s flame patterns.
Make sure the flames are steady - not lifting or floating.
See Figure 16. The thermopile/thermocouple (standing pilot)
tips should be covered with flame. See Figure 6.

Figure 16. Burner Flame Patterns

MAKE SURE THE FLAMES
ARE STEADY—NOT
LIFTING OR FLOATING.

Checking Vent System
Frequency:
Before initial use and at least annually
thereafter, more frequently if possible.
By: Qualified service technician/Home owner.
Task: Inspect the external vent cap on a regular basis to
ensure that no debris is interfering with the flow of air. Inspect
entire vent system for proper function.

Cleaning Glass Door
Frequency:
After the first 3 to 4 hours of use. As neces-
sary after initial cleaning.
By: Home owner.
Task: Remove and clean glass after the first 3 to 4 hours of
use. After the initial cleaning, clean as necessary, particu-
larly after adding new ember (flame colorant) material. Film
deposits on the inside of the glass door should be cleaned
off using a household glass cleaner. NOTE: DO NOT handle
or attempt to clean the door when it is hot and DO
NOT use abrasive cleaners.

Advertising