T+A Elektroakustik K 6 - Manual (Page 17)

17 Operation
The Tuner as alarm clock
Operation:
    Switch on Tuner mode
TUNER TUNER TUNER TUNER
then e.g.
WDR 2 WDR 2 WDR 2 WDR 2
   
press
for 2 sec.
Open Alarm Menu By RDS ON By RDS ON By RDS ON By RDS ON
   
   
Select menu point
    /     Change menu point
    Activate selection
or
    Close Alarm Menu
Explanation:
The K6 includes a timer module which can switch the
unit on at a pre-set time. The 'Alarm Menu' provides
access to all the settings which are required for the alarm
function.
The alarm function only works in Tuner mode. This is to
ensure that a source signal is actually present when the
unit is switched on by the timer!
Hold the     button pressed in until the 'Alarm
Menu' opens.
The menu appears on the TV set connected to the sys-
tem; the integral screen shows the first menu point.
Clock:
This function lets you set the internal clock manually to
the correct time using the
    /     buttons. At first the
time changes slowly, but if you hold the button pressed
in the rate of change increases.
Note
Setting the clock manually is only possible if you have
selected manual in the 'Set clock' menu point.
Setting the clock:
In this menu point you determine how the internal clock
is to be set.
manual You can set the time of day manually in
the 'Clock' menu point
by RDS The time of day is read automatically from
the RDS signal, and accepted by the K6;
this only works if a high-quality RDS signal
is present. If you pick this option you can-
not change the time of day manually.
Alarm:
The alarm function can be switched on and off in this
menu point.
on Alarm function switched on
off Alarm function switched off
Note
When the timer is switched on, the Timer symbol is
displayed on the integral screen.
Alarm time:
This function lets you set the alarm time manually using
the
    /     buttons. At first the time changes slowly,
but if you hold the button pressed in the rate of change
increases.
Loudspeaker:
In this menu point you set which loudspeakers
(
    A /     B) are active when the alarm is triggered.
A Loudspeakers A (in main room) switched on
B Loudspeakers B (in adjacent room) switched on
A+B Loudspeakers A and B switched on
Alarm volume
    A /     B:
In this menu point you can adjust the alarm volume for
speakers
    A (main room) and     B (adjacent room)
separately. However, this is only possible if you have
already set the Volume A/B menu point to split in the
'Loudspeaker Menu'. When you change the volume
using the
    and     buttons, the system immediately
accepts the indicated level so that you can hear the new
volume.
Program for alarm:
Selects the program which is to be selected when the
alarm is triggered, using the
    /     buttons.