T+A Elektroakustik K 6 - Manual (Page 47)

47 Setting up
    FM ANT - aerial input
The K6 features a 75 Ohm VHF aerial input (domestic
aerial or cable).
    STB (SCART
1)
)
Socket for connecting a set-top box (SAT or cable re-
ceiver) with SCART connection
1)
.
    MAINS FUSE
It is essential to use a replacement fuse rated exactly as
printed on the case.
    MAINS INPUT
The mains cable is connected to this socket. When con-
necting the unit to the mains it is essential to read and
observe the notes in the sections 'Setting up, using the
K6 for the first time' and 'Safety Notes'.
    TV (SCART
1)
)
Input / output socket for connecting a TV set with SCART
connector.
    VCR / TV B (SCART
1)
)
Socket for connecting a video recorder.
Alternatively: connection for a TV set in an adjacent
room.
    AUX AV (STEREO CINCH and VIDEO)
Input for connecting an additional AV source device.
1)
Note
If your AV device does not feature a SCART socket, use
a SCART adaptor cable connected to the VIDEO (Cinch)
or S-VIDEO (Hosiden) input / output socket of your AV
device. Ask your specialist
    dealer for advice if you
are not sure.
        A - FRONT
Terminals for front loudspeakers
2)
        B
Terminals for loudspeakers in adjacent room
2)
    PRE OUT (CONTROL)
Connection for     active loudspeakers, to be used as
front speakers in the main listening room.
Note
This socket also supplies a switching signal which can
be used to activate other devices (e.g. projectors, pro-
jection screens etc.) automatically via the K6 (see 'Ap-
pendix B').
        A - REAR
Terminals for surround loudspeakers
2)
        A - CENTER
Terminals for center loudspeaker
2)
Note:
If the loudspeakers are to be used in countries outside
the EU the red/black stoppers can be removed from the
loudspeaker terminals. The speakers can then be con-
nected using banana plugs.
The stoppers are simply a push-fit in the terminals, and
can be prised out from the rear using a suitable tool such
as a knife blade.
2)
Notes
The impedance of the loudspeakers connected to the K6
should not be less than 4 Ω
Ω Ω Ω (DIN rating).
It is essential to check that the screw terminals are firmly
tightened, and that there are no stray strands of cable
which could cause a short-circuit.
The terminals also feature cross-holes into which standard
insulated 'banana plugs' (4mm) can be fitted from the
underside.
The     accessory range includes a selection of high-
quality cables which are an exact match to     equip-
ment.