T+A Elektroakustik K 6 - Manual (Page 55)

55 Appendix
Cause 3: K6 not set to surround mode.
Remedy: Set to surround mode, or select one of
the sound fields.
Cause 4: Programme contains no information on
the auxiliary channels (e.g. stereo ma-
terial).
Remedy: If you wish, call up the 'Main Menu' and
select a sound field.
Cause 5: The level for the channel affected is set
too low.
Remedy: Call up 'Loudspeaker Balance Menu'
and raise the level.
Problem: No bass, or inadequate bass.
Cause 1: No subwoofer connected, but activated
in 'Loudspeaker Menu'.
Remedy: Connect subwoofer, or disable sub-
woofer in 'Loudspeaker Menu'.
Cause 2: Size of loudspeakers entered incor-
rectly in 'Loudspeaker Menu'.
Remedy: Call up 'Loudspeaker Menu' and
check that settings match the loud-
speakers in your system; correct if
necessary.
Problem: The signal from an analogue source
device occasionally suffers distor-
tion during very loud passages. The
integral screen shows
' O V E R L O A D ' ' O V E R L O A D ' ' O V E R L O A D ' ' O V E R L O A D '
Cause: The analogue/digital converter is over-
loading.
Remedy: Re-calibrate the analogue/digital converter
to this source device. See 'Inputs Menu'.
Picture problems:
Problem: 'Main Menu' not displayed on the
television screen.
Cause: On-screen display of 'Main Menu'
switched off in 'Configuration Menu'.
Remedy: Call up 'Configuration Menu' and
switch on 'On-screen Menu'.
Problem: No picture from some or all source
devices.
Cause: Source devices not supplying the
switching signal which the TV set re-
quires to switch over to AV mode.
Remedy: Set television to 'constant AV opera-
tion' mode.
Problem: Neither on-screen menu nor other
external programs appear on the TV
screen. TV only shows those sta-
tions which are received via its own
aerial.
Cause 1: Video cable not connected properly.
Remedy: Push in all connectors firmly.
Cause 2: The TV set does not switch automati-
cally to the AV input.
Remedy: Set the TV to 'AV mode'.
Problem: Picture unstable.
Cause: Synchronisation signal absent.
Remedy: Push connector in firmly, or set TV to
'AV mode'.
Problem: Monochrome picture only.
Cause: Incompatible video norms set on the
TV, the K6 and the source device.
Remedy: Set TV, K6 and source device to the
same video norm.
Note: If problems persist, set the K6 to the
'RGB / Video' norm; select the video
norm 'Video' (occasionally also termed
'CVBS' or 'Composite') on the TV set
and the source device.
Problem: Nothing appears on the integral
screen.
Cause: The screen is switched off.
Remedy: Switch the screen on again (see

   button).
Problem: The automatic 4:3 / 16:9 format
switch does not work.
Cause 1: The TV set is not exploiting the switch-
ing signal supplied through the SCART
cable.
Remedy: Switch TV set to 'controlled AV opera-
tion' mode, or switch TV set manually.
Cause 2: The source device is not supplying the
requisite switching signal.
Remedy: Switch TV set manually.
Cause 3: You are using the wrong cables. The
switching signals are only passed via
SCART cables.
Remedy: Use SCART cables.