Toshiba DKT3001/2001 - Manual (Page 60)

DSS Console
DSS Button
48
Strata CTX DKT3001/2001 Digital Single Line Telephone 01/02
When the called station answers the call, the DSS LED stays steady red, and the
Line LED becomes steady red.
4. If the station does not answer before a period set in system programming, the call
recalls your station.
Call Transfer with Camp-on
You can transfer a call to a busy station from a DSS console. Use the DSS to transfer
the call, even though the DSS LED associated with the station you are “transferring
to” is red.
➤
To transfer call to a busy station
1. Press DSS corresponding to the busy station to be called.
You may hear a busy tone. The original caller is placed automatically on hold. The
Line LED flashes at double the on-hold rate, and the DSS LED remains steady red.
2. Hang up.
The call rings the called station once with the camp-on tone. While the called
station is receiving this tone, the Line LED flashes green (on-hold rate) or if you
are on a extension button, it goes idle. The DSS LED remains steady red.
When the called station answers the transferred call, the Line LED becomes steady
red. The DSS LED remains steady red.
Note If the busy station is in the Do Not Disturb mode, the call will not transfer, but
will recall your telephone immediately.
If the call is not answered after a specified Recall time set in system programming,
camp-on is cancelled and the transferred call rings back.
Call Answering (Outside Line)
If your DSS console is equipped with a /LQH button, you can answer outside line calls
from the DSS console as you would from a digital telephone.
➤
To answer an incoming outside line call to a DSS Console
➤
Press the flashing /LQH .