Toshiba CT - Manual (Page 143)

Strata CIX and CTX IPT/DKT Telephone 09/06
127
Call Transfer with Camp-on
You can transfer a call to a busy station from either a DSS console or an DADM. Use
the DSS to transfer the call, even though the DSS LED associated with the station you
are “transferring to” is red.
To transfer call to a busy station
1. Press DSS corresponding to the busy station to be called.
You may hear a busy tone. The original caller is placed automatically on hold. The
Line or extension LED flashes green at double the on-hold rate, and the DSS LED
remains steady red.
2. Hang up.
The call rings the called station once with the camp-on tone. While the called
station is receiving this tone, the Line LED flashes green (on-hold rate) or if you
are on a extension button, it goes idle. The [DSS] LED remains steady red.
When the called station answers the transferred call, the Line LED becomes steady
red. The [DSS] LED remains steady red.
Note If the busy station is in the Do Not Disturb mode, the call will not transfer, but
will recall your telephone immediately.
If the call is not answered after a specified Recall time set in system programming,
camp-on is cancelled and the transferred call rings back.
Call Answering (Outside Line)
If your DADM or DSS console is equipped with a Line button, you can answer
outside line calls from the DADM or DSS console as you would from a digital
telephone.
To answer an incoming outside line call to a DADM or DSS Console, press the
flashing Line .
Speed Dial
Your DADM or DSS console may be equipped with SD (Speed Dial) buttons that can
be programmed to dial telephone numbers or to access features. SD buttons on either
the DADM or DSS console function like SD buttons on digital telephones.