Toshiba CT - Manual (Page 56)

Advanced Operation
Call Forward
40
Strata CIX and CTX IPT/DKT Telephone 09/06
• Call Forward Busy/Do Not Disturb/No Answer – Forwards all calls to your
station whenever you are busy, in the DND mode, or after ringing and you do not
answer the call within a designated time (set by you when you enable the feature).
• Call Forward Cancel – Cancels the set Call Forward feature. Notice that each
category of Call Forward has a different code for canceling.
Station Call Forward Procedures
Table 2 , “Call Forward Procedure” contains Call Forward Button sequences. You can
do a Call Forward function by, one, entering the button sequence as described, or two,
by programming a Flexible Button to perform the sequence. See “Programming
Feature Buttons” on page 113 for instructions on programming a Flexible Button.
To use the Call Forward button sequence
Follow the instructions in the following table, shown under “Button Sequence.”
Some features require additional input, such as:
• Dest. Ext. or Telephone No. – CF destination numbers can be internal
extension numbers or outside telephone numbers. If the destination is an
outside number, enter the access code used for dialing out (such as 9 ) + the
telephone number + # . The CIX accepts destination numbers of up to 32 digits.
(See following examples).
• Timer – Enter the number of seconds (08~60) your telephone should ring
before forwarding the call. (This is the CF-No Answer timer.)
• CF Pass Code – A four-digit Call Forward (CF) pass code established by
system programming is required to allow one station to set CF for another
station. This code is also used to allow DISA callers to set CF for another
station. Users must enter the CF pass code for the station to be forwarded.
Note
In Table 2 , (tone) means that confirmation tone (three short tones) will play at
that point in the sequence to confirm your input was accepted.