Trilogy Touch Technology Trilogy Commander Digital Intercom 9 - Manual (Page 21)

Commander Installation Guide
Issue 9 Trilogy Communications Limited Page 21 of 81
3.3 INSTALLING PATHFINDER
PathFinder is the configuration editor for the Trilogy Commander intercom system. Details of
PC specification and operating system requirements are given in Section 9.6. Software is
supplied on CD-ROM. For a new installation, insert the disk in the PC CD drive.
Unless there are exceptional reasons otherwise, we strongly recommend that you accept all
the defaults offered during the software installation process. Following this, you will be
prompted that a system re-start is required, which again should be followed to provide
correct operation.
There are now some important settings to carry out before using PathFinder.
• System name and number
• The matrix size.
• Commander interface method and settings.
Start PathFinder, entering the CD key code when prompted. This is attached to the CD jewel
case and should be carefully retained for future PC installations. Follow the options to create
a New Database. From the Options pull down menu, select Settings and the form shown
below will be displayed.
From the Windows start menu,
click Run, then type x:PathFinder
4_nn\Disk1\setup.exe where x is
the CD drive letter and nn is the
version sub-code (e.g. 21).
Alternatively, browse to the
location using Windows Explorer.