Setting up the audio options, System setup, 38 - english – Toshiba D-VR3SB User Manual
Page 38: Digital output, Dynamic compression
38 -
English
Allow you to setup the Audio device and sound status
depending on the audio system in use.
Note
Note
Digital Output
Setting Up the Audio
Options
Use the
❷
buttons to select the desired item.
Then press the
❿
or OK button.
1. PCM :
Converts to PCM(2CH) 48kHz audio.
Select PCM when using the
Analogue Audio Outputs.
2. Bitstream :
Converts to Dolby Digital/MPEG
Bitstream (5.1CH). Select Bitstream
when using the Digital Audio Output.
DTS
1. Off :
Doesn’t output digital signal.
2. On :
Outputs DTS Bitstream via digital out-
put only. Select DTS when connecting
to a DTS Decoder.
Dynamic Compression
1. On :
To select dynamic compression.
2. Off :
To select the standard range.
5
Press the RETURN or
➛
button to return to
the previous menu. Press the MENU button to
exit the menu.
When DTS soundtrack is played, sound does
output from Analog Audio Output.
With the DVD in Stop mode, press the MENU
button on the remote control.
1
Select “Setup” using
❷
buttons, then press
the
❿
or OK button.
2
Select “Audio” using
❷
buttons, then press
the
❿
or OK button.
Audio setup menu will be displayed.
3
PCM
Bitstream
Programme
Use
❷
buttons to select the desired sub menu
and press the
❿
or OK button.
4
Programme
S
ystem Setup