Toshiba D-VR3SB - Manual (Page 79)

English - 79
R
ecording
Recording through a DV
jack
Connect the DV output jack of your camcorder to
the DV input jack on the front of your DVD
Recorder-VCR using a DV cable. 1
Power on your DVD Recorder-VCR and switch
to DV mode by pressing the INPUT SEL. on the
remote. 2
With your DVD Recorder-VCR stopped, set the
operation mode of your camcorder to play mode. 3
Press the z (REC) button on your DVD
Recorder-VCR when the image from which you
want to start recording is displayed.
4
Press the (STOP) button on your DVD
Recorder-VCR when the recording is finished.
5
Follow these directions to record onto a disc the outputs
of a camcorder that has a DV output jack.
DVD-RAM DVD-RW DVD-R
„ Some camcorders may not work with your
DVD Recorder-VCR even if they have a DV
output jack.
„ Also refer to the user manual for your
camcorder when recording through a DV jack.
Note
Start Recording
Press the REC button on the remote control or
front panel.
For options while recording is in progress, see
“Special Recording Features”.
3
Basic VCR Recording
Insert Tape
Insert a blank Video tape into the VCR deck.
• Make sure the tape is long enough to record
the entire program.
To change the Recording Speed, see page 80.
1
Select a Programme to Record
Use the 0–9 buttons or the PROG/TRK /
buttons to select the desired Programme, or
press the INPUT SEL. button to select AV1, AV2
or AUX or DV if recording from an external
device connected to the front or rear inputs,
respectively.
2
1. Check TV Programme and Antenna connections.
2. Check the remaining time on the tape.
You can record a TV show in progress by inserting a
blank tape and pressing the
z
(REC) button. You can
even add time in 30-minute increments up to 9 hours by
pressing the
z
(REC)button repeatedly; see page 71.
„ Be sure your videotape has a Record Safety
Tab. If the tab is missing, you can cover the
opening with a small piece of tape. Warning:
Do not cover this opening unless you are sure
you want to record over the tape.
Note
Pause/Resume Recording
Press the II (REC PAUSE) button.
Press z (REC) again to resume.
4
Stop Recording
Press the „ (STOP) button.
5