Toshiba RD-XS24SB - Manual (Page 15)

15
Connections
Basic setup
Introduction
To wall outlet
Notes
• Refer to the owner’s manual of the connected TV as well.
• When you connect the recorder to your TV, be sure to turn off the power and unplug both units from the wall outlet before any
connections.
• Connect the recorder directly to your TV. If you connect the recorder via a VTR, TV/VTR combination or video selector, the
playback picture may be distorted due to copy protection.
• When “PSO” is displayed on the front panel display, the picture is output only from the COMPONENT OUT (Y, P B , P R ) jacks.
( page 17)
3
Connect to a TV equipped with SCART inputs.
Connect as below for watching received channels or recorded contents. Watching via the RF OUT terminal
is not available.
4
Connect the power cord of the recorder to a wall outlet.
SCART cable (not supplied)
To AV1(TV)
To SCART input
• Normal TV
• TV compatible with S video signals
• RGB monitor
• The following setting is required according to the TV that
you are connecting.
For connections to TVs with no SCART
inputs, see “Connecting to a TV equipped
with phono type jacks” (
page 16).
Setting
“AV1 output” on the “Initial
settings” menu.
page 32
Normal TV “Video”
TV compatible with S video signals “S-Video”
RGB monitor “RGB”
TV
RD-XS24SB_inst(E)_13-20 8/31/05, 5:40 PM 15