Toshiba RD-XS24SB - Manual (Page 31)

31
Connections
Basic setup
Introduction
2: Input signal setting
Make a selection according to the video system of receiving broadcasts or recording sources from the input sockets.
1 Press SETUP if the setup menu is not displayed.
2 Press / to select “Initial settings”, then press ENTER.
3
Press / to select “Input signal”, then press
ENTER.
4
Press / to select the video input signal
type, then press ENTER.
PAL : Select when viewing and/or recording PAL
signals broadcasted mainly in England.
Additionally select when recording PAL
signals from the AV1(TV) socket, the
AV2(EXT) socket, or the LINE jacks on the
front panel.
SECAM : Select when recording SECAM signals from
the AV1(TV) socket, the AV2(EXT) socket, or
the LINE jacks on the front panel.
Auto : The recorder automatically identifies PAL or
SECAM video system of receiving broadcasts
or recording sources. Some signal conditions
of the broadcasts or the sources may prevent
correct detection. In this case, select “PAL” or
“SECAM” according to the broadcast or the
source.
• To exit the menu, press the SETUP button.
Initial settings
Channel setting Auto
Time & date setting Auto
e.g.
SECAM
Auto
PAL
AV1 output Video
Video
AV2 input
Input signal PAL
1
On Clock set position
Just clock
1 2 3
4 5 6
7 8 9
+10 0
TV DVD
INPUT SELECT
CHANNEL
MODE
RETURN
SLOW/REV FWD/SLOW
PLAY
STOP
PAUSE
REC
SKIP REV SKIP FWD
–ADJUST ADJUST+
TV/DVR DELETE
CLEAR
EXIT
ENTER
QUICK MENU
OPERATION
INSTANT
SKIP
INSTANT
REPLAY
NUMBER
HDD DVD
TOP MENU MENU
MENU TIMESLIP
CHANNEL VOLUME INPUT SELECT
OPEN/CLOSE
CHP DIVIDE ANGLE SUBTITLE AUDIO
REC MODE ZOOM SEARCH DISPLAY
PROGRESSIVE EXTEND SETUP REMAIN
Start
ENTER
ENTER
RD-XS24SB_inst(E)_31-33 8/31/05, 5:41 PM 31