Toshiba RD-XS24SB - Manual (Page 41)

41
Connections
Basic setup
Introduction
Setting up the remote control
5
Set the OPERATION/NUMBER switch to
“NUMBER”.
6
While pressing MODE, press 2 (example).
The remote control mode is set to DR 2.
Select the same mode that you have set to the recorder.
Be sure to set the OPERATION/NUMBER switch to
“OPERATION” after having entered numbers.
Notes
• If the recorder’s mode and the remote control’s mode are different, the recorder’s mode (DR 1, DR 2 or DR 3) appears in the
display of the front panel.
• When the batteries of the remote control are replaced or when the time indicator of the front panel flashes, check the remote
control modes of both the recorder and the remote control, and re-program if necessary.
Disabling the remote control for a temporary period
You can temporarily disable the reception of the remote control signals at the recorder, when the selection of DR 1,
DR 2 and DR 3 is not sufficient while you are using several Toshiba HDD/DVD video recorders.
Press HDD and DVD on the recorder at the same time for three seconds or more.
The recorder display shows “dR - OF”, indicating that the remote control is disabled.
To enable the remote control, perform the same step again. (The display shows “dR-1 , dR-2 or dR-3” depending on
your setting.)
Notes
• This function is not available in Standby mode.
• You cannot use this feature when the power is turned off, if you have set “Eco. mode” to “On”. (
page 126 in
“OPERATIONS”)
MODE
2
PLAY
Mode
Mode setting
Recorder Remote control
DR 1
DR 2
DR 3
DR 2
DR 3
DR 1
DR 2
DR 3
DR 1
DR 2
DR 3
DR 1
OPERATION
NUMBER
1 2 3
4 5 6
7 8 9
+10 0
MODE
RETURN
SLOW/REV FWD/SLOW
PLAY
STOP
PAUSE
REC
SKIP REV SKIP FWD
–ADJUST ADJUST+
TV/DVR DELETE
CLEAR
EXIT
ENTER
QUICK MENU
OPERATION
INSTANT
SKIP
INSTANT
REPLAY
NUMBER
HDD DVD
TOP MENU MENU
MENU TIMESLIP
CHP DIVIDE ANGLE SUBTITLE AUDIO
REC MODE ZOOM SEARCH DISPLAY
PROGRESSIVE EXTEND SETUP REMAIN
MODE
1
SLOW/REV
+
MODE
2
PLAY
+
MODE
3
FWD/SLOW
+
RD-XS24SB_inst(E)_34-41 8/31/05, 5:42 PM 41