Power/serial data cable, Event marker/1pps cable, Power/serial data cable event marker/1pps cable – Trimble Outdoors 5700/5800 User Manual
Page 100: 5700 gps receiver oper ation
10 Cables and Connectors
8 8 5700/5800 GPS Receiver User Guide
5700 GPS Receiver Oper
ation
10.2
Power/serial data cable
Table 10.2 gives pinout information for the power/serial data cable
(PN 32345), which is supplied with the 5700 receiver.
Note – Table 10.2 assumes that the cable is attached to the connector
labeled Port 1 or Port 3.
10.3
Event Marker/1PPS Cable
The event marker/1PPS cable shown in Figure 10.3 provides a breakout
box with two BNC ( female) connectors for providing 1PPS input and
event marker output.
Connect a device that accepts 1PPS output pulses to the BNC
connector labeled 1PPS on the breakout box. Connect a device that
outputs event marker pulses to the 5700 receiver, such as a
photogrammetric camera, to the BNC connector labeled Event Marker
on the breakout box.
Table 10.2
Power/serial data cable pinouts
Lemo 0-shell
connector
7 Pin
Directio
n
DE9-F connector
7 Conductors
Power lead
2 Conductors
Pin
Function
Pin
Color
Function
Color
Function
1
Signal ground
↔
5
Brown
Signal ground
2
GND
→
Black
V-OUT
3
TXD
→
2
Orange
TXD
4
RTS/TXD
→
8
Blue
RTS
5
CTS/RXD
←
7
Green
CTS
6
PWR
←
Red
Power IN (+)
7
RXD
←
3
Yellow
TXD