Deleting files in the receiver, Supported file types, 5700 gps receiver oper ation – Trimble Outdoors 5700/5800 User Manual
Page 76
6 Transferring Data
6 4 5700/5800 GPS Receiver User Guide
5700 GPS Receiver Oper
ation
A new file with the same filename but a .dat extension appears in
the same folder as the .T01 file.
6.1
Deleting Files in the Receiver
You can delete files stored in the 5700 receiver at any time. Do one of
the following:
•
Use the Data Transfer utility in Trimble Geomatics Office.
•
Use the controller.
•
Hold down the power button
[P]
for 30 seconds after the receiver
has been powered on. (When you use this method,
all data is
deleted, and the CompactFlash card is reformatted.)
•
Use GPS Configurator.
6.2
Supported File Types
Table 6.1 shows the file types that you can transfer to or from a 5700
receiver, and the software or utility that you must use to transfer each
file type.
Note – The 5700 receiver supports a maximum of 512 files on the
CompactFlash card. Files stored on the compact flash must be 8.3 format.
The 5700 receiver does not support extended file names.
Table 6.1
Supported file types
File Type
Extensions
Transfer from
5700 receiver?
Transfer to
5700 receiver?
Software
Ephemeris .eph
Yes
No
Data
Transfer
Raw observations
.T01, .dat
Yes
No
Data Transfer
Receiver firmware files
.elf
No
Yes
WinFlash
Application files
.cfg
Yes
Yes
GPS
Configurator