Uniden WNP1000 - Manual (Page 19)

37
For Windows 2000:
1. Click on Start, Settings, Control Panel. Double click
on Network and Dial-up Connections.
2. Right click on the Local Area Connection that is
associated with the network adapter you are using,
and select the Properties option.
3. In the “Components checked are used by this
connection” box, highlight Internet Protocol
(TCP/IP), and click the Properties button.
Note: PLEASE WRITE DOWN THE IP ADDRESS or THE BOX
FOR “OBTAIN AN IP ADDRESS AUTOMATICALLY” WAS
CHECKED ON THE “MEMO” PAGE OF THIS MANUAL,
PAGE 57.
After you’ve configured the Access Point, you
will need to re-enter either the IP Address or check the
box for “Obtain an IP Address Automatically” into your
computer. Follow these same steps, but enter the
information YOU wrote down on the “Memo” page of
this manual, page 57.
4. Select Use the following IP address option. Enter a
unique IP address that is not used by any other
computer connected to the network. You can only use
an IP address in the range of 192.168.1.1 to
192.168.1.254. Make sure that each IP address is
unique for each PC or network device.
5. Enter the Subnet Mask, 255.255.255.0.
6. Click the OK button in the “Internet Protocol (TCP/IP)
Properties” window, and click the OK button in the
“Local Area Connection Properties” window.
7. Restart the computer if asked.
38
For Windows NT 4.0:
1. Click on Start, Settings, Control Panel. Double click
on Network.
2. Select the Protocol tab, and double click on TCP/IP
Protocol.
3. When the window appears, make sure you have
selected the correct Adapter for your network adapter.
Note: PLEASE WRITE DOWN THE IP ADDRESS or THE BOX
FOR “OBTAIN AN IP ADDRESS AUTOMATICALLY” WAS
CHECKED ON THE “MEMO” PAGE OF THIS MANUAL,
PAGE 57.
After you’ve configured the Access Point, you
will need to re-enter either the IP Address or check the
box for “Obtain an IP Address Automatically” into your
computer. Follow these same steps, but enter the
information YOU wrote down on the “Memo” page of
this manual, page 57.
4. Select “Specify an IP address”, and enter a unique IP
address that is not used by any other computer
connected to the network. You can only use an IP
address in the range of 192.168.1.1 to 192.168.1.254.
Make sure that each IP address is unique for each PC
or network device.
5. Enter the Subnet Mask, 255.255.255.0.
6. Click the OK button in the “TCP/IP Properties”
window, and click OK in the “Network” window.
7. Restart the computer if asked.