Uniden WNP1000 - Manual (Page 5)

9
c) Connect the computer directly to the WNP1000
Wireless AP using a “crossover” Ethernet cable.
If you wish to setup the WNP1000 Wireless AP by using an
802.11b enabled PC, make sure the 802.11b client is in
“Infrastructure” mode, and has an SSID of “UNIDEN” or blank.
The default IP address of the WNP1000 Wireless AP LAN
interface is 192.168.1.10 and the default network mask
255.255.255.0.
The Configuration Interface
The WNP1000 Wireless AP incorporates a browser-based
management/configuration interface. The following sections
guide you through configuring your WNP1000 Wireless AP and
detailing the information found within each section.
Logging In
Open a web browser on your computer configured for TCP/IP
networking. Make sure that the computer and the
WNP1000 Wireless AP are on the same local area
network, with similar IP addresses. (If you are having
trouble communicating with your Access Point, please
see “Troubleshooting” on page 37.)
10
1. Type “http://192.168.1.10/” into the Location field
(or the URL field) at the top of the browser window
and hit the Enter key. This is the same location were
you type in the web address such as
http://www.uniden.com. (192.168.1.10 is the default
IP address of the
WNP1000 Wireless AP.)
Once you hit the Enter key, the “Enter Network
Password” window will appear.
2. Type “admin” (lower case) in the User Name field,
leave the Password field blank, and click OK.
The General Information web page will appear next.
3. After you are logged into the Access Point you can
change the User Name and Password.