Uniden WNP1000 - Manual (Page 3)

5
Installing the Hardware
Physical Installation
Select a safe location for the WNP1000 Wireless AP. You may
install the WNP1000 Wireless AP either upright on a desk or
bookcase using the included stand, or mount the WNP1000
Wireless AP on a wall using the two screws as shown in the
figure below. Leave adequate room for the antennas to unfold
and allow adequate cable length for both the power and
Ethernet cables.
Powering the AP
Plug the power adapter into an AC power outlet and connect
the output of the power supply to the power jack on the rear of
the WNP1000 Wireless AP. The power LED should turn On
(Blue) immediately.
6
Connecting the Device to Computers and Network
When you connect the WNP1000 Wireless AP to a switch or
router, check the WNP1000 Wireless AP LAN LED.
Solid green indicates a link to a fast Ethernet Switch
(100Mbps). Solid amber indicates a link to a 10Base-T Switch.
Flashing indicates activity. A typical configuration is shown in
the figure below.