Uniden NEO TRUC56 - Manual (Page 15)

GETTING ST
ARTED
G E T T I N G S TA R T E D [ 13 ]
• Use only the supplied AD-430 AC adapter.
Do not use any other AC adapter.
• To charge the handset, slide the handset down until it clicks.
• Connect the AC adapter to a continuous power supply.
• Place the base unit close to the AC outlet so that you can unplug
the AC adapter easily.
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack and
to a standard 120V AC wall outlet.
2) Set the base on a desk or tabletop, and place
the handset in the base unit as shown.
3) Raise the antenna to a vertical position.
4) Make sure the status LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in
and that the handset makes good contact with the base
charging contacts.
Place the power cord so
that it does not create
a trip hazard or where
it could become chafed
and create a fire or
electrical hazard.
• After installing the battery pack in the handset, charge your handset at least 3-5 hours
before plugging into the phone line. Once the handset battery pack is fully charged,
connect the telephone line cord to the base and telephone wall outlet.
5) Connect the telephone line cord to the TEL LINE jack and to
a telephone outlet once the handset is fully charged.
If your telephone outlet isn't modular type,
contact your telephone company for assistance.
Modular
TRUC56_OM 12/11/02 9:24 AM Page 13