Uniden NEO TRUC56 - Manual (Page 25)

BASICS
[ 23 ] B A S I C S
“Distinctive Ringer” allows you to preset memory locations with a designated ring tone.
When an incoming call is received and the Caller ID information matches the information in
one of the memory locations, the Distinctive Ring that has been stored for that particular
caller will sound.
If you have set multiple memory locations with distinctive rings, switching the setting to
“
Distinctive Off ” will result in no distinctive ringing. All incoming calls will have a
normal ring tone. Switching to “ Distinctive On ” will activate all programmed
distinctive ring memory locations.
1) When the phone is in the standby mode, press MENU/MUTE .
2) Press UP or DOWN to move the pointer to “ Distinct. Ring ”,
then press SELECT/CH .
3) Press UP or DOWN to choose “ Distinctive On ” or
“ Distinctive Off ”.
4) Press SELECT/CH , and you will hear a confirmation tone.
5) Press END to exit.
Distinctive Ringer Setup
Adjusting the Earpiece Volume
The handset earpiece volume settings (Volume Low, Volume Medium, Volume High, and
Volume Maximum) can only be adjusted during a call. Press
UP or DOWN to select the
volume setting. When you hang up, the phone keeps the last volume setting selected.
See ”Storing Phone
Numbers, Names,
Distinctive Rings, and
Speed Dial” on page 27
for storing a Distinctive
Ring in the Phonebook.
When you press UP in maximum volume level or DOWN in lowest volume level, an error tone sounds.
TRUC56_OM 12/11/02 9:25 AM Page 23