Uniden NEO TRUC56 - Manual (Page 41)

CALLER ID
C A L L E R I D [ 39 ]
Calling a party from the Caller ID list
From Standby mode
1) Press
CID/ s . The summary screen appears. The screen shows
the number of new messages and the total number of messages.
2) Use the number keypad ( 2 - 9 and 0 ), UP , or DOWN to view the
Caller ID message list.
3) Press TALK/FLASH . The displayed phone number dials automatically.
From Talk mode
1) Press
TALK/FLASH .
2) Press CID/ s . The summary screen appears.
3) View the Caller ID message you want to dial.
4) Press
SELECT/CH . The displayed phone number will be dialed.
Long Distance calls and Area Code Setting/Cancellation
While the incoming Caller ID information is displayed, pressing ✱ /TONE will place or
remove the prefix “ 1 ” in the display to set the call for a long distance call, or pressing #
will set or cancel an area code. (See page 16.)
Storing Caller ID messages in the Phonebook/RocketDial
Messages shown in the Caller ID list can be stored in the phonebook. Using the incoming
call information (i.e., Caller ID list), the phone number of the party on the Caller ID list
can be stored in memory.
1) When the phone is in the standby mode, while the incoming
Caller ID information is displayed, press PB/ROCKET/ t .
2) Press UP or DOWN to choose “ Store in PB? ” (Phonebook
locations) or “ Store in SD? ” (RocketDial location). To
cancel Storing, select “ Cancel ”.
Using the Caller ID Message List
• You cannot make a call
from the Caller ID list if
your phone is connected
to a private branch
exchange (PBX).
• When a long distance
call has been set, “ 1 ”
appears in the display.
• If a call comes in via a
telephone system that
does not offer Caller ID
service, no information
is stored.
Talk
8002971023
TRUC56_OM 12/11/02 9:26 AM Page 39