U-Line 30 - Manual (Page 14)

14
Using a Household Power Source
1. Turn the POWER switch to OFF.
2. Connect the power cord to the
power adapter.
3. Plug the power cord into a power
outlet.
4. Connect the power adapter to the
camcorder’s DC IN terminal.
❍ Turn off the camcorder before connecting or disconnecting the power adapter.
❍ If the adapter is used close to a TV, it may cause picture interference. Move the
adapter away from the TV or the antenna cable.
❍ Do not connect any products that are not expressly recommended to the
camcorder’s DC IN terminal or to the power adapter.
❍ You may hear some noise from the power adapter during use. This is not a
malfunction.
❍ Do not disconnect and reconnect the power cord while charging a battery
pack. Charging may stop. The battery pack may not be charged correctly even
if the CHARGE indicator glows steady. The battery pack may also not be
charged correctly when a power outage occurs during charging. Remove the
battery pack and attach it back to the camcorder.
❍ When the power adapter or battery pack is defective, the CHARGE indicator
flashes rapidly (at about 2 flashes/second) and charging stops.
❍ The CHARGE indicator informs you about the charge status.
0-50%: Flashes once every second
More than 50%: Flashes twice every second
100%:
Glows steadily
❍ Charging, Recording and Playback Times
Below times are approximate and vary according to the charging, recording or
playback conditions.
* Approximate times for recording with repeated operations such as start/stop, zooming,
power on/off. Actual time may be shorter.
q
w
e
r
NB-2LH NB-2L BP-2L12 BP-2L14
Charging Time 115 min. 110 min. 180 min. 210 min.
Max. Recording Viewfinder 90 min. 70 min. 145 min. 185 min.
Time LCD 75 min. 55 min. 120 min. 155 min.
Typical Recording Viewfinder 50 min. 40 min. 80 min. 100 min.
Time* LCD 40 min. 30 min. 70 min. 85 min.
Playback Time 105 min. 85 min. 175 min. 220 min.