U-Line 30 - Manual (Page 90)

90
5. Press the AUDIO DUB. button on the wireless
controller.
“AUDIO DUB.” and “
a” appear.
6. Press the PAUSE a button on the wireless controller
to begin dubbing.
• Audio device: Begin playback.
• Microphone: Speak into the microphone.
7. Press the STOP 3 button on the wireless controller
to stop dubbing.
Audio device: Stop playback.
❍ Use only tapes recorded in SP mode 12-bit audio sound with this camcorder.
Audio dubbing will stop if the tape has a blank section or a section recorded in
LP mode or 16-bit mode.
❍ When using the built-in microphone, do not connect any devices to the MIC
terminal or the advanced accessory shoe. When using the DM-50 Directional
Stereo Microphone, do not connect any devices to the MIC terminal.
❍ You cannot use the DV terminal for audio dubbing.
❍ If you add sound to a tape not recorded with this camcorder, sound quality
may decrease.
❍ Sound quality may decrease when you add sound to the same scene for more
than 3 times.
❍ When you connect an audio device, check the picture on the LCD screen and
the sound via built-in speaker or audio device. You can also connect a TV via S-
video terminal.
❍ When you use the built-in microphone, you can either connect a TV via AV
terminal to check the picture, or headphones to check the sound. When you
connect a TV via S-video terminal, you can check the picture on the TV screen
and the sound with headphones connected to the camcorder.
❍ Set the zero set memory at the end of the scene you wish to dub audio. The
camcorder will automatically stop audio dubbing at that point.
REW
PAUSE
AV DV REMOTE SET
SLOW 2
PLAY
STOP
FF
ZERO SET
MEMORY
12bit
AUDIO OUT
AUDIO DUB.
REW
PAUSE
AV DV REMOTE SET
SLOW 2
PLAY
STOP
FF
ZERO SET
MEMORY
12bit
AUDIO OUT
AUDIO DUB.
REW
PAUSE
AV DV REMOTE SET
SLOW 2
PLAY
STOP
FF
ZERO SET
MEMORY
12bit
AUDIO OUT
AUDIO DUB.