Universal Electronics Polaris - Manual (Page 12)

www.urcsupport.com
12
PROGRAMMING DEVICE CONTROL
The Polaris Remote Control is preprogrammed to
operate the cable box (converter) provided by your cable
company, and an RCA TV. To control devices other than
the default brands, perform the following steps;
otherwise skip this section.
NOTE:
If you have another brand of cable converter
you would like to control, you’ll need to
unlock the cable ID Lock before changing the
converter code (see “Programming ID Lock”
on page 14).
1. Turn on a device.
NOTE: Please read steps 2 through 4 completely
before proceeding. Highlight or write down
the codes and device you wish to program
before moving on to step 2.
3. Use the “Manufacturer’s Codes (Códigos del
Fabricante)” starting on page 39) to locate the
type of device and brand name and then enter
the first four-digit code for your device. If
performed correctly, the selected mode key
blinks twice.
NOTE: If the selected mode key emits a long blink,
the entry is invalid. Repeat steps 2 through 3
and try entering the same code again.
5. Repeat steps 1 through 4 for the other device
you want the remote control to operate (either
TV or CBL). For future reference, write down
each working device code in the boxes on the
following page.
CBL Code
2. On the remote control, press a device key once
(i.e., TV or CBL); it blinks once. Then press
and hold SETUP until the selected mode key
blinks twice.
4. Aim the remote control at the device (either
TV or CBL) and press the key for that device
once. The device should turn off. If it does
not, repeat steps 2 through 3, trying each code
for your brand until you find one that works.
If it still does not respond, try searching for
the code (see “Searching for Your Code” on
page 13).