Universal Electronics Polaris - Manual (Page 15)

www.urcsupport.com
15
1. Turn on the cable converter.
4. Perform the instructions under
“Programming Device Control” on page 12 to
program device control for the desired cable
converter.
When you are done, perform steps 5 and 6 on
this page to again lock the ID Lock.
LOCKING THE VOLUME TO YOUR CABLE BOX
Normally, the Polaris Remote Control is locked to
control the volume of your television only. However, if
you have an older television that does not have a remote
control for the volume, you have to control your
television’s volume through your cable box. To lock the
volume control to your cable box, perform the steps
below:
2. On the remote control, press CBL once; it
blinks once. Then press and hold SETUP until
the CBL key blinks twice.
3. Enter 9 8 2. The CBL key blinks four times,
indicating ID Lock is unlocked.
5. On the remote control, press CBL once; it
blinks once. Then press and hold SETUP until
the CBL key blinks twice.
6. Enter 9 8 2. The CBL key blinks twice,
indicating ID Lock is again locked.