Universal Electronics Polaris - Manual (Page 4)

www.urcsupport.com
4
blink, then the code entry was
incorrect. Try steps 2 and 3 again,
using the same code.
5. Repeat steps 1 through 4 above for the
next device you want to control (either
your television or cable box).
OPERATE YOUR CABLE BOX
Your Polaris Remote Control is now ready to
operate your cable box. You can use your
remote control to turn your cable box on and
off, and to change the channel.
To change the channel, do the following:
OPERATE YOUR TELEVISION
To turn on your television, press TV. The TV key
blinks once and your television turns on. To
4. Aim the remote control at the device
you want to control. Press the key for
that device once (either TV or CBL). If
the device turns off, then you have
successfully programmed your remote
control for that device. If the device
does not turn off, then repeat steps 2
through 4 until you have found the
code for that device.
1. To turn on your cable box, press CBL.
The CBL key blinks once and your
cable box turns on. To turn off your
cable box, press CBL. The CBL key
blinks once and your cable box turns
off.
1. Use the remote control's CH+ and CH-
keys to navigate to the channel you
wish to view, one channel at a time.