Ultratec PRO80 - Manual (Page 6)

General Precautions
● SAVE THESE INSTRUCTIONS!
● Read and understand all instructions.
● Follow all warnings and instructions on the
Superprint Pro80 LVD.
● Unplug the Superprint Pro80 LVD from the wall
outlet and refer servicing to qualified service personnel
under the following conditions:
✔
When the power supply cord or plug is damaged
or frayed.
✔ If liquid has been spilled into the TTY.
✔ If the TTY has been exposed to rain or water.
✔ If the TTY does not operate normally when the
operating instructions are followed.
✔ If the TTY has been dropped and/or damaged.
✔ If the TTY exhibits a distinct change in
performance.
● Adjust only those controls that are covered by the
operating instructions. Improper adjustment of other
controls may damage the Superprint Pro80 LVD.
● To clean: Unplug the Superprint Pro80 LVD from the
wall outlet. Use a damp cloth. Do not use liquid or
aerosol cleaners.
● Do not use the Superprint Pro80 LVD near water, for
example, near a bath tub, wash bowl, kitchen sink,
laundry tub, in a wet basement or near a swimming
pool.
● Always place the Superprint Pro80 LVD on a stable
phone stand, table or other secure surface. Dropping
the Superprint Pro80 LVD can result in serious
damage to the equipment.
● The Superprint Pro80 LVD should be operated only
from the type of power source indicated on the label.
If you are not sure of the type of power supply to your
home, consult your dealer or local power company.
● Do not allow anything to rest on the power cord. Do
not position the Superprint Pro80 LVD where people
can walk on the cord.
● Do not overload wall outlets and extension cords. This
overloading can result in a fire or electric shock.
● Never attempt to open, disassemble or service the
Superprint Pro80 LVD. All repairs should be
performed by an authorized service center. Opening or
removing covers exposes you to the risk of dangerous
voltages and other hazards. If reassembled incorrectly,
the Superprint Pro80 LVD can become an electrical
shock hazard.
● Avoid using a telephone (other than a cordless type)
during an electrical storm. There is a remote risk of
electric shock from lightning.
● Do not use the telephone to report a gas leak in the
vicinity of the leak.
● Ultratec recommends plugging your Superprint
Pro80 into a surge-protected outlet. This will
protect the TTY from damage caused by
electrical surges due to lightening or other causes.
Battery precautions
● Use only the type and size battery specified in the
instructions for your unit. NEVER USE NiMH OR
ALKALINE RECHARGEABLE BATTERIES.
● Do not dispose of the batteries in a fire. Cells may
explode. Check local codes for possible special disposal
instructions.
● Do not open or mutilate the batteries. Battery
electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
● Exercise care in handling batteries in order not to
short them with conducting materials such as rings,
bracelets, and keys. The battery or conductor may
overheat and cause burns.
i v • S A F E T Y I N S T R U C T I O N S
SAFETY INSTRUCTIONS
CAUTION: To reduce the risk of fire, electrical shock and personal injury,
always follow these basic safety precautions when using the Superprint
Pro80 LVD.