Vizio rp56 user guide, Remote control operation – Vizio RP56 User Manual
Page 36
VIZIO RP56 User Guide
040330 33
Remote Control Operation
Common Sense Cautions
Do not drop or mishandle the remote control.
Do not get the remote control wet. If the remote control gets wet,
wipe it dry immediately.
Avoid heat and humidity.
When not using the remote control for a long period, remove the
batteries.
Do not take apart the batteries, heat them, or throw them into a
fire.
Using the PIP Remote Control
The PIP Remote Control is exclusively for control of all PIP mode options. In addition, the Universal
Remote Control can also be used to control the PIP mode options.
o Press the red PIP button on the PIP Remote Control to activate the PIP (Picture-In-Picture)
mode. The PIP (sub screen) window will appear on the screen superimposed on the main
screen. When you press this button again it will deactivate the PIP mode and the window will
disappear.
o Press
the
SIZE + button to increase the size of the PIP window. Each press of the button will
increase the window size one step; holding the button depressed will cause size of the window
to be increased step-by-step automatically.
o Press
the
SIZE - button to decrease the size of the PIP window. Each press of the button will
decrease the window size one step; holding the button depressed will cause size of the window
to be decreased step-by-step automatically.
o When the PIP window is visible, press the SWAP button and the main picture will switch to PIP
window and the PIP picture will replace it on the main screen. Press the SWAP button again
and the pictures will switch back again.
o When the PIP window is visible, press the STYLE button and the DLP TV will show the main
and sub pictures as a split screen with the screen being divided equally between the two
pictures but the content will be squeezed into the half width so that people will appear long and
thin. Press the STYLE button again and will change to POP (Picture-On-Picture) mode in
which both pictures are equal again but this time the height is adjusted to match the width of
each picture so that people are in the correct proportions. Press the STYLE button again and
the format will change to Main+3 mode which means there is a large main picture and three
smaller sub pictures stacked on the right side of the screen; each one of the sub pictures in turn
becomes live for a few seconds after which it freezes while the other two take their turn in being
live. Press the STYLE button again and the format will change to Main+7 mode which means
there is one larger main picture and seven smaller sub pictures arranged along the top and
right edge of the screen and they alternate between live and freeze as for the previous mode.
Press the STYLE button again and the format will change to Scan mode in which the screen is
split into a grid of twelve equal size pictures the first of which, (top left) is the main picture and
the eleven sub pictures are refreshed as in the previous two modes. Press the STYLE button
again and the format will change to PIP mode, which is where cycle of choices began.
o Press
the
SOURCE button one or more times to select the video input desired.
Note:
The DVI or RGB input cannot be used as a sub picture source.