Vizio RP56 - Manual (Page 52)

VIZIO RP56 User Guide
040330 49
Troubleshooting Guide
Use the following information to solve common problems.
Symptom Possible Solutions
No picture Make sure that the power cord is plugged into a grounded
electrical outlet.
Make sure that the Power button is turned on.
Look in the left air vent to see if the lamp is on.
Make sure that the selected input source is connected to a
working component. If the other component is not working,
correct the problem with the other component.
If the DLP TV is connected to a computer in RGB mode
check to see if the computer has gone to sleep and if so,
press any key on the keyboard to “wake” the computer.
The picture is distorted or there is
an unusual sound. Check if there is interference from other electrical
appliance, car, motorcycle or fluorescent light. Try moving
the DLP TV or offending appliance to another location.
The color is abnormal. Check that the input source cable is connected securely
and correctly to the back of the DLP TV.
There are abnormal patterns on
the picture. Check that the input source cable is connected securely
and correctly to the back of the DLP TV.
Make sure that the video input source is within the range of
the DLP TV. Compare the video input source’s
specifications with the DLP TV specifications.
The picture does not fill the whole
screen. If the TV, AV1, AV2 or component is being used with 480i
input, use the screen width or WIDE button on the remote
control to scroll through various screen modes.
There is a picture but no sound. Make sure that the volume is not turned down.
Make sure that the sound is not muted.
Make sure that the internal speakers are not turned off.
Make sure that the audio input source cables are
connected securely and correctly.
The DLP TV has pixels that are
always dark. The DLP TV is manufactured using an extremely high level
of precision technology. However, sometimes pixels may
not display. Pixel defect within the industry specifications
are inherent to this type of product and do not constitute a
defective product.
There is “noise” or “trash” on the
picture. When the DLP TVs digital capabilities exceed a digital
broadcast signal, the signal is up-converted (increased) to
match the DLP TVs display capabilities. This process may
cause “noise” or “trash” on the screen.
Screen brightness is diminished. Video display components experience degradation of
brightness over the life of the component. Normal
brightness degradation is not covered by the warranty.