Vista Imaging Vista Routing - Manual (Page 60)

Using the Routing Gateway Routing User Guide
5 Position and size the terminal window for subsequent monitoring. (Note that no new
information will be shown in the terminal window until the evaluation processor
encounters entries in the rule evaluation queue.)
Starting the Transmission Processor
1 Open a new terminal window and log into the DICOM Gateway software.
2 Enter 3 to select “Routing Gateway” from the DICOM Gateway Menu [ MAGDMENU ].
3 Enter 1 to select “Start the Transmission Processor.”
4 A list of destinations will be displayed. To select all possible destinations, enter an
asterisk (*). To enter a partial list, follow the instructions at the prompt.
Possible destinations are:
125: KANSAS at \\TELERAD3\wichita
152: ST LOUIS CR at \\vhastlvistarad
164: IMAGPROVIDER1 at C:\REMOTE\IMAG1\
166: LEAVENWORTH, KS at C:\REMOTE\LVW\
167: IMAGPROVIDER2 HOME at C:\REMOTE\IMAG2\
168: ST. LOUIS, MO at C:\REMOTE\STL\
Select destinations by:
==> Enter their number(s), separated by commas
==> Enter an asterisk (*) to select all possible destinations
Prefixing an entry with a dash deselects the listed
destinations
Enter a period when the selection is complete.
---> *
5 The destinations you selected will be displayed. Enter a period when you are finished.
6 Position and size the terminal window for subsequent monitoring.
 As the transmission processor sends exams to Imaging destinations, it will map
and un-map certain drives. For more information, see page 66 .
7 To start additional transmission processors, repeat steps 1 – 6 in a new terminal
window.
VistA Imaging V. 3.0, Patch 18 April 2006 52