3 start the evaluation processor, 4 stop the evaluation processor, 5 import routing rules – Vista Imaging Vista Routing User Manual

Page 64

Advertising
background image

Using the Routing Gateway

Routing User Guide

3 Start the Evaluation Processor

When this option is executed, the evaluation processor will begin examining
routing-specific entries in the rule evaluation queue. This file is populated by Image
Gateways (provided that Image Gateways are configured as part of a routing system).

The evaluation processor uses the rule evaluation queue and site-specific routing rules to
determine which images are to be routed and where they are to be routed. Entries for
images to be autorouted are added to the transmission queue.

Typically, a single instance of the evaluation processor can manage all images produced
at the sending site. For consolidated sites, an instance of the evaluation processor should
be started for each location. (In this situation, a “location” equates to an entry in the

IMAGING SITE PARAMETERS

File (#2006.1).)

4 Stop the Evaluation Processor

Use this option to stop the evaluation processor. When this option is executed, a flag is
set that the evaluation processor will recognize as “stop evaluating.” The evaluation
processor checks this flag after analyzing each image file against the routing rules.

5 Import Routing Rules

When this option is executed, the rules in

\DICOM\Dict\Route.dic

will be loaded into

the Routing Gateway’s local MUMPS environment. For detailed steps about importing
routing rules, see page

44

.

6 Purge all completed entries in the Transmission Queue

Use this option to reduce the size of the transmission queue in test installations.
Executing this option will remove entries for files that have been transmitted
successfully.

 This option is intended for use at test sites. If this option is used, routed images

will be “orphaned” at a destination—rather than being deleted automatically (after
the defined retention period); the images will remain until deleted manually.

To purge completed entries without orphaning routed images, use the option described in
the next section.

VistA Imaging V. 3.0, Patch 18

April 2006

56

Advertising